Skip to main content Link Menu Expand (external link) Document Search Copy Copied
Kindle Modding Wiki

KT2

Popcorn is quite a sophisticated jailbreak method and requires prior electronics experience. It is not recommended to use Popcorn unless you have prior electronics experience especially if a software jailbreak such as WatchThis is available for it.

Make sure you have followed the initial Popcorn instructions

Performing the Jailbreak

  1. Tear down the KT2 up to step 5 as described here
  2. Connect a wire between test pads TP1706 and TM401 as shown in this picture: Jumpers
  3. Whilst those points are connected, hard reboot the Kindle by holding down the power button for 15 seconds
  4. Plug the Kindle into your PC

If everything went well, the device is now in SDP Mode and ready to be flashed

Windows

On Windows, simply locate the folder you extracted earlier, double click on MFGTool.exe to run it and then click on Start and wait for it to complete.

You are now ready to check the Post Jailbreak section for what to do now.

Linux

On Linux, open a new terminal and navigate to the folder which contains the folder named imx_usb_loader

If you run ls it should show the imx_usb_loader folder, run the following command:

sudo imx_usb -c imx_usb_loader/wario

And wait for it to complete.

You are now ready to check the Post Jailbreak section for what to do now.

Credits